About the Classroom
Our Classroom is well equipped with Flat Panel Creative Board, Audio visual aid, fully AC enviornment. Class Time for each module remains 50 Minutes.


Use-case for building IoT based Applications A. Using Arduino and sensors/actuators
i. Interfacing Light Emitting Diode(LED)- Blinking LED : This use case will be used for familiarizing the GPIO peripheral of atmega micro controller. The LED will be used as a device and GPIO will work as output mode.
ii. Interfacing Button and LED LED blinking/glow when button is pressed This use case will help to understand the GPIO in two different modes, Input - Button and LED - output mode.
iii. Interfacing Light Dependent Resistor (LDR) and LED, displaying automatic night lamp .This use case will help to understand ADC peripheral and how to read analog data from sensors.
iv. Interfacing Temperature Sensor(LM35) and/or humidity sensor (e.g. DHT11) This use case will help to connect traditional environmental monitoring sensors (Temperature and humidity) to the Arduino development board. Also use the suitable libraries for implementing these case studies.
v. Interfacing Liquid Crystal Display(LCD) display data generated by sensor on LCD This case study will demonstrate how to provide local display unit with Arduino micro controller. Use suitable libraries for implementing these case studies.
vi. Interfacing Air Quality Sensor-pollution (e.g. MQ135) - display data on LCD, switch on LED when data sensed is higher than specified value. This use case will help to understand how to use traditional smart pollution management sensors with Arduino platform for developing applications as a part of smart city projects.
vii. Interfacing Bluetooth module (e.g. HC05)- receiving data from mobile phone on Arduino and display on LCD This use case will help to understand the connectivity solution to Arduino to a gadget like mobile phone. Bluetooth is used as connectivity solution in this application.
viii. Interfacing Relay module to demonstrate Bluetooth based home automation application. (using Bluetooth and relay). This use case will enable the IoT node capability of Arduino development boards by integrating actuator (relay connected to GPIO) to Arduino board and remote connectivity (Using Bluetooth) using a mobile phone with the help of a readily available Bluetooth serial application. Contact Information Contact any teacher on the telephone number 01893-293410 or submit your query on the website.